Inkl. moms.
Leveringstid: 2–5 hverdage · Norge
The internal barrier limits product soaking into the foam core. Your detailing product stays available in the outer microfibre instead of unnecessarily saturating the core, helping you spread coating or wax with control.
The microfibre itself absorbs product; this is intentional for application. Start with a small amount and add more as needed. Always follow your coating's application instructions.
13 × 8 × 3.5 cm, with soft 300 GSM microfibre made from 80% polyester and 20% polyamide. The broad contact area spreads product evenly over bonnets, roofs and larger body panels. The soft sponge is comfortable to hold, and both sides can be used.
For manual application of compatible ceramic and graphene coatings, waxes and care products. Thoroughly clean the surface first and prepare it as the product requires.
1 pack contains 4 applicators; 5 packs contain 20 applicators. For tighter areas, add the Mini Applicator.
After applying a curing coating, discard the applicator once that application is complete. Coating can harden in the fibres. These residues must not come into contact with paintwork again.
For non-curing care products, reuse is possible after thorough cleaning: wash at up to 30 °C without fabric softener and air dry completely. Check for hardened areas and particles before reuse. Use separate applicators for different products.
Controlled coating application on large areas
Put valuable coating where it is needed. The internal absorption barrier limits product uptake into the foam core, leaving more material available in the outer fibres for application.
Cover large areas evenly. The broad contact surface and easy-grip foam core support steady, controlled application. Guide the applicator in overlapping passes and keep track of the area you have covered.
Soft 300 GSM microfibre for gentle contact. Fine fibres spread compatible coatings and waxes without vigorous rubbing. A thoughtfully designed tool for professional paint care, with four fresh applicators per pack.
Thoroughly clean the paintwork and prepare it according to the coating's instructions. Have a clean, soft applicator ready.
Apply a small amount of product to the microfibre. Spread over small sections in overlapping passes with light pressure.
Observe the coating's flash time and removal instructions. Remove excess with a suitable cloth, then discard the coating applicator.
Never reuse an applicator containing cured coating on paintwork. Use a separate clean sponge for each product.
